Label:
Audi
take care of one&;s health
Use a car
Hello. 1. Zero the maintenance lamp without changing the original maintenance mileage and maintenanc:1, enter &”;17 instrument cluster&”; control module 2, select &”;Match function 10&”; function 3, enter &”;02&”; channel 4, change the memory value from &”;1&”; to &”;0&”;, Confirmation 2. If the original maintenance mileage and maintenance days are changed, the maintenanc:1) According to the requirements of the maintenance station, enter 00 000 for :5,000 km and 90-day 1.17-10-02, then turn off the ignition switch and turn it back on. MMI displays the maintenance mileage and maintenance days. 2. There is no maintenance data prompt. Re-enter 17-10-40 (mileage adaptation after maintenance), enter 100 (= 5,000 km) for testing and save. 3. Then enter 17-10-41 and enter 275(=90 days). This data is set by the maintenance station. 4. Turn off the ignition switch and turn on the ignition switch again. MMI shows that there are 5000KM and 90 days before the next maintenance. Enthusiastic users 2013-09-04 Audi&;s maintenance tips removal methods: 1. There is a button on the dashboard, which is used to adjust the mileage. Press and hold this button for 2-3 seconds at idle speed. Maintenance prompt is off. 2. Turn off the engine for more than three seconds (don&;t pull out the key), press and hold the mileage reset lever, and turn the key to on. At this time, turn the lever for adjusting the clock clockwise. You can set it in MMI and use a computer to set it in the lower left corner of the instrument. There are two buttons. 1) Press the mileage reset button and turn on the ignition switch for 2S. 2) Press the time adjustment again. See if it is cleared, otherwise, repeat the above two steps. 2. Use VAS5052 to zero. 1) Turn off the ignition switch. 2) Use VAS5052 to enter the 002 group of instrument matching function, change the matching value from 001 to 000, and press Q to confirm and save. What needs to be changed by the testing computer can&;t be changed in the car. I hope my answer can help you to press and keep the buttON A on the right side of the meter (that is, the one next to the odometer) and the ignition switch on. &”;SERVICE&”; or &”;SERVICE IN*MI&”; will appear on the LCD. Release button a. Press the key B on the left side of the meter (that is, at the right hand of the tachometer) to reset the display, and the character &”;SERVICE IN 10000MI&”; appears on the LCD. With the ignition switch OFF, you can. If your car is equipped with maintenance-free instrument panel, you must use appropriate diagnostic equipment. With the diagnostic instrument, enter the instrument system. Enter the channel number 10-2 (the maintenance cycle display reset is used to eliminate the maintenance prompt, just enter 0). The car needs to change the oil, do the maintenance, and the maintenance indicator is still on. You need to use the car computer detector to do the maintenance reset, and the indicator will go out! A4 maintenance tips of Audi can&;t be reset manually, and need to be decoded by a special diagnostic instrument.Use the diagnostic instrument to guide the inquiry or input the channel number to decode. Please go to the 4S shop to handle the specific operation.